Ip address, Automatic configuration, Manual configuration – HP LaserJet P2055dn User Manual
Page 52: Ipv4 and ipv6 settings
IP address
The product IP address can be set manually, or it can be configured automatically via DHCP, BootP, or
AutoIP.
Automatic configuration
1.
On the control panel, press
OK
.
2.
Use the arrow buttons to select Network config., and then press
OK
.
3.
Use the arrow buttons to select either BOOTP or DHCP, and then press
OK
.
4.
Use the arrow buttons to select Yes, and then press
OK
.
It may take several minutes before the automatic IP address is ready for use.
5.
Use the
Back
or
Cancel
button to leave the Network config. menu.
NOTE:
Specific automatic IP modes (such as BOOTP, DHCP, or AutoIP) can be changed by using
the embedded Web server or HP ToolboxFX only. If AutoIP is disabled, HP default IP (192.0.0.192) will
automatically be enabled.
Manual configuration
1.
On the control panel, press
OK
.
2.
Use the arrow buttons to select Network config., and then press
OK
.
3.
Use the arrow buttons to select CFG TCP/IP, and then press
OK
.
4.
Use the arrow buttons to select BOOTP, make sure the value is No, and then press
OK
.
5.
Use the arrow buttons to select DHCP, make sure the value is No, and then press
OK
.
6.
Use the arrow buttons to select IP BYTE 1, and then press
OK
.
7.
Use the arrow buttons to change the value of IP BYTE 1, and then press
OK
.
8.
Repeat steps 6 and 7 for IP BYTE 2, IP BYTE 3, and IP BYTE 4. Also, repeat steps 6 and 7 for
the Subnet Mask (SM BYTE 1, SM BYTE 2, SM BYTE 3, SM BYTE 4) and Default Gateway (GW
BYTE 1, GW BYTE 2, GW BYTE 3, GW BYTE 4).
9.
Use the
Back
or
Cancel
button to leave the Network config. menu.
IPv4 and IPv6 settings
The IPv4 and IPv6 protocols can be configured manually. The IPv4 protocol can be set from
HP ToolboxFX or from the product control panel. The IPv6 protocol can be set from the product control
panel or the embedded Web server.
40
Chapter 5 Connectivity
ENWW