HP XP P9000 Command View Advanced Edition Software - Manual (Page 112)

Related topics
• About Add Command Devices Wizard , page 113
About command devices
A command device is necessary in order for P9000 RAID Manager (a prerequisite product for
Replication Manager) to communicate with storage systems. Replication Manager allows you to set
up command devices in open systems if the storage system type is XP12000/XP10000/SVS200, or
XP24000/XP20000.
Related topics
• About Add Command Devices Wizard , page 113
• Setting up command devices , page 111
• Editing command devices , page 306
• Deleting command devices , page 307
Storage system types and volume requirements (command devices)
Volumes that meet the requirements listed here are displayed as candidate volumes in Replication
Manager.
Storage system types and requirements for using volumes as command devices
XP24000/
XP20000/
HP P9500 XP12000/
XP10000/
SVS200
Requirement
Y Y Volume not a paired volume
Y Y Volume not an external volume
Y Y Volume not a virtual volume
Y Y Volume access attribute must be Read or Write
Y Y Volume not reserved for Auto LUN
Legend:
Y: This requirement applies.
Command device settings for virtual machines
The Replication Manager command device configuration function cannot be used to set a volume as
a command device if the volume has been allocated for a VMware virtual machine.
To set a command device for the virtual machine:
1. Use Remote Web Console to set the volume as a command device.
2. Use Remote Web Console to add the command device in (1) to a VMware host group and set
a path for the command device.
3. Perform VMware Raw Device Mapping, and then make sure that the command device in (1) is
recognized by the virtual machine.
Setting up storage systems 112