HP Officejet Pro 8500 - Manual (Page 88)

You can receive faxes manually from a phone that is directly connected to the device
(on the 2-EXT port) or that is on the same phone line, but not directly connected to the
device.
To receive a fax manually
1. Make sure the device is turned on and you have paper loaded in the input tray.
2. Remove any originals from the document feeder tray.
NOTE: The automatic document feeder must be empty to receive a fax. If
there are documents in the document feeder, then receiving the fax will be
unsuccessful.
3. Do one of the following:
• Turn off Auto Answer.
• Set Rings to Answer to a high number.
4. If you are currently on the phone with the sender, instruct the sender to press Start
on their fax machine.
5. When you hear fax tones from a sending fax machine, do the following:
a. Press START FAX Black or START FAX Color on the device control panel.
b. When prompted, select Fax Receive.
NOTE: Depending on your country/region, the device might receive the fax
automatically when you hear fax tones from the sending fax machine.
6. After the device begins to receive the fax, you can hang up the phone or remain on
the line. The phone line is silent during fax transmission.
Set up backup fax reception
Depending on your preference and security requirements, you can set up the device to
store all the faxes it receives, only the faxes it receives while the device is in an error
condition, or none of the faxes it receives.
The following Backup Fax Reception modes are available:
On The default setting. When Backup Fax Reception is On, the device
stores all received faxes in memory. This enables you to reprint up to
eight of the most recently printed faxes if they are still saved in memory.
NOTE: When device memory is low, it overwrites the oldest, printed
faxes as it receives new faxes. If the memory becomes full of unprinted
faxes, the device stops answering incoming fax calls.
NOTE: If you receive a fax that is too large, such as a very detailed
color photo, it might not be stored in memory due to memory limitations.
On Error Only Causes the device to store faxes in memory only if an error condition
exists that prevents the device from printing the faxes (for example, if the
device runs out of paper). The device continues to store incoming faxes
as long as there is memory available. (If the memory becomes full, the
device stops answering incoming fax calls.) When the error condition is
resolved, the faxes stored in memory print automatically, and then they
are deleted from memory.
Chapter 8
84 Fax