Clean the paper path – HP LASERJET PRO P1102w User Manual
Page 86
Clean the paper path
If you are experiencing toner specks or dots on the printouts, clean the paper path. This process uses a
transparency to remove dust and toner from the paper path. Do not use bond or rough paper.
NOTE:
For best results use a sheet of transparency. If you do not have any transparencies, you can
use copier-grade media (60 to 163 g/m
2
(16 to 43 lb)) that has a smooth surface.
1.
Make sure that the product is idle and the ready light is on.
2.
Load media in the input tray.
3.
Open the printer Properties.
4.
Click the Device Settings tab.
5.
In the Cleaning Page area, click the Start button to process the cleaning page.
NOTE:
The cleaning process takes about 2 minutes. The cleaning page stops periodically during the
cleaning process. Do not turn the product off until the cleaning process has finished. You might need to
repeat the cleaning process several times to thoroughly clean the product.
72
Chapter 7 Manage and maintain the product
ENWW