GE GDT580SSFSS - Manual

Dimensions and Installation Information (in inches)
For answers to your Monogram, ® Cafe ™ Series,
Profile ™ Series or GE ® appliance questions, visit
our website at geappliances.com or call GE
Answer Center ® service, 800.626.2000.
As an EnErgy StAr ®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
24"
Typical
33-3/8" MIN.
adj to
34-5/8" MAX.
23-3/4"
29-7/8"
27-1/2"
4"(toekick)
Includes 3/4" custom panel
GDT580SGF/SMF/SSF
GE ® Stainless Steel Interior Dishwasher with Hidden Controls
Specification Revised 7/13 350297
Listed by
Underwriters
Laboratories
• The rough cabinet opening must be at least 24" deep,
24" wide and approximately 34-1/2" high from floor to
underside of the countertop.
4"
6"
5" 5" 4"
Figure A
Floor MUST be Even
With Room Floor
Cabinets
Square
and
Plumb
This Wall Area
must be Free
of Pipes or
wires
24"
Min.
24"
Min.
33-1/2" to 34-3/4"
Underside of
Countertop
to Floor
Plumbing and Electric Service
Must Enter Inside This Area
Electrical Rating
Voltage AC.......................................................... 120
Hertz..................................................................... 60
Total connected load amperage............. 7.1
Calrod
® heater watts......................... 415/800
For use on adequately wired 120-volt,
15-amp circuit having 2-wire service
with a separate ground wire. This appliance
must be grounded for safe operation.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.