GE JP328SKSS - Manual

Dimensions and Installation Information
JP328SK
GE ® 30" Built-In Electric Cooktop
For answers to your Monogram, ® or GE ® appliance
questions, visit our website atge.com or call GE
Answer Center
® service, 800.626.2000. Specification Revised 3/14 321348
Listed by
Underwriters
Laboratories
Electrical junction box 16" MIN.
below countertop
30" MIN. to
unprotected
cabinet
Cut should
not interfere
with cabinet
structure
at front
5-1/2"
clearance to
side wall
from cut-out
2"
clearance to
side wall
from cut-out
18" MIN.
to cabinet
1-3/4" to
rear wall
13" MAX.
depth
† Note: Check local codes for required breaker size
Important: Maintain 5" (12.7 cm) minimum
vertical clearance between the cooktop bottom and
any combustible surfaces. Clearance not required
when installing wall oven underneath. Requires an 18"
minimum from cooktop to adjacent overhead cabinets.
Units are furnished with a 48" flexible armored cable.
Cooktop models JP328WK/328BK/328CK/328SK are
approved for use over GE 27" or 30" Single Wall Ovens.
Refer to cooktop and wall oven installation instructions
packed with product for current dimensional data.
If installed with a
GE Telescopic Downdraft System,
consult both cooktop and downdraft installation
instructions packed with product before installing.
Cooktop gas/electric supply may need to be re-routed
to install downdraft.
The countertop must be at least 26" deep with a flat
surface area of 23-1/2" or more, front to back. In
addition, other clearances to the front edge of the
countertop must be considered.
This cooktop
cannot be installed in countertops that
cannot accept screws, such as granite or marble, etc.
Filler Trim Kit: When replacing an old GE 30" cooktop
(with larger opening) use the following one-piece trim kit
to fill in the over-size hole. Available at additional cost.
JXTR31W (White) JXTR31C (Bisque) JXTR31B (Black)
KW Rating
240V 7.4
208V 5.6
Breaker Size
240V 40 Amps †
208V 30 Amps †
Cooktop
2-1/2"
(min.)
28-1/2"
19-1/2"
30-1/4"
21-1/4"
3