Installing the charcoal filter, Installation instructions – GE JVM6175DFWW User Manual

Page 22

Advertising
background image

5

6

3

4

2

1

INSTALLING THE
CHARCOAL FILTER

C5.

MOUNT THE MICROWAVE
OVEN (cont.)

C4.

Install the charcoal filter. When properly installed,
the wire mesh of the filter should be visible from
the front.

Replace the panel and the screws.

Close the door.

22

Charcoal
Filter

Insert mesh-side up

Remove the 3 screws that secure the front panel
from the top of the microwave oven.

Open the door and remove the panel.

Push the filter at the bottom until it comes free
of the locking tabs. Slide the filter down and out.

Installation Instructions

8

7

6

Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)

Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.

Tighten center
screw completely.

Install grease filter. See the Owner’s Manual
packed with the microwave.

5

Attach the microwave oven to the top cabinet.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Microwave Oven Top

Equivalent to Depth
of Cabinet Recess

3 Insert a self-aligning screw through top center

cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.

Self-Aligning Screw

4

Advertising
This manual is related to the following products: