GE JRP28BJBB - Manual (Page 4)

REPLACE THE OVEN DOOR
3. Put the oven into the cabinet and use a 1/8" drill
bit to drill holes in the cabinet front through the
holes in the oven trim.
4. Secure the oven in the cabinet with the screws
provided.
5. The lower trim should be mounted to the bottom
of the oven frame with the 3 screws provided.
To remove the oven door:
1. Open the door to the stop position (see Fig. 3A).
2. Grasp the door at each side and lift up and off the
hinges (see Fig. 3B).
CAUTION:
When the door is removed and hinge
arms are at stop position, do not bump
or try to move the hinge arms. The
hinges could snap back causing an
injury to the hands or damage to the
porcelain on the front of the range.
Cover the hinges with toweling or
empty towel rolls while working in the
oven area.
STOP! STOP!
1. Hold the door over the hinges with the slots at
the bottom edge of the door lined up with the
hinges.
2. Slide the door down onto the hinges as far as
it will go and close the door.
STOP POSITION
HINGE
Fig. 3A Fig. 3B
The lower front trim is packed separately and
should be added after the oven is installed. The
oven door must be removed to install the
lower trim.
The trim provides cooling air entry into
cabinet through the bottom opening.
The bottom opening should never be
blocked. See Fig. 3B.
STOP! STOP!
4
INSTALLING OVEN
— Printed in the United States —
Recycled Paper