GE PGP990SENSS - Manual

Listed by
Underwriters
Laboratories For answers to your Monogram ® or GE ® appliance
questions, visit our website at geappliances.com
or call GE Answer Center
® service, 800.626.2000. Specification Revised 3/13
230283
Wall Installation: Wall installations require 25” countertop depth. When
cabinet is flush against the wall, the fan housing can be rotated to the
horizontal position for direct venting through rear wall. Make a countertop
cutout in the range cabinet according to unit dimensions and installation
type. Duct hole is positioned in back of cabinet for through-the-wall ducting.
Requires special offset adapter JXRW89.
Peninsula or Island Installation: For peninsula/islands a minimum
26” countertop depth is suggested. Blower should be in vertical position.
Island or peninsula cabinets may require adjustment in cutout depth and/or
location within the width dimensions. Duct hole is positioned in bottom of
cabinet for island or peninsula installation.
Slab Installation: For peninsula or island installation
and rear wall ducting,
6” PVC duct or locally approved piping
should be used if installing under a poured concrete slab.
Installation Information: Before installing, consult installation instructions,
packed with product, for current dimensional data.
Note: These cooktops are approved for indoor use only.
Warranty Information:
Parts Warrany - Limited 1-year entire appliance
Labor Warranty - Limited 1-year entire appliance
Warranty Notes - For models produced on or after January 1, 2006;
see written warranty for full details
Tie down bolt
on each end
Select appropriate
duct cutout
(see ducting installation instructions).
Pressure regulator
Wiring box cover
Grease
container
9-1/2
29 ±1/16
1-7/8"
Min.
15/16"
Min.
clearance
Blower can be swiveled 90°
14-3/16
9
30 21-3/4
21 ±1/16
PGP990SEN
GE Profile ™ Series Built-In Downdraft Gas Cooktop
Dimensions and Installation Information (in inches)