GE ZET1SMSS - Manual

Listed by
Underwriters
Laboratories
KW Rating
240V 4.3
208V 3.9
Breaker Size
240V 20 Amps
208V 20 Amps
Overlap Dimensions
Left Right Top Bottom
1/2 1/2 5/16 9/16
For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
geappliances.com or call GE Answer Center ®
service, 800.626.2000.
Installation Flexibility
These ovens may be installed below a countertop and beneath
approved cooktops. They may also be installed in combination
with an Advantium oven and a warming drawer. They may also
be installed side by side. This oven is not approved for stackable,
one over another installations.
Note: Cabinets installed adjacent to wall ovens must have an
adhesion spec of at least a 194°F temperature rating.
Installation Information: Before installing, consult installation
instructions packed with product for current dimensional data.
Dimensions and Installation Information (in inches)
ZET1SM
GE Monogram ® 30” Built-In Single Oven
28-1/2" Min.
28-5/8" Max.
27-1/4" Min.
27-5/16" Max.
23-1/2"
Min.
Locate Junction Box 22"
Above Cutout Floor, Within 5"
of Right Rear Wall
30"
28-1/4"
23-1/4"
Recessed
Depth
29-3/4" 32-1/2"
28-1/2" Min.
28-5/8" Max.
27-1/4" Min.
27-5/16" Max.
23-1/2"
Min.
Locate Junction Box 22"
Above Cutout Floor, Within 5"
of Right Rear Wall
30"
28-1/4"
23-1/4"
Recessed
Depth
29-3/4" 32-1/2"
130188 Specification Revised 8/12
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts. The solid bottom or runners must be level with the bottom of the
cutout, or the bottom trim may not install correctly and could
interfere with the door opening. If the cabinet does not have a
solid bottom, two braces or runners must be installed level with
the bottom of the cutout to support the weight of the oven. The
runners and braces must support 200 lbs. (90 kg).
Note: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
2 (5.1 cm) Min.
2 (5.1 cm) Min.
Per Advantium or
Microwave Oven
Requirement
Per Warming Drawer
Requirement