GE ZGG420NBPSS User Manual

Outdoor built-in cooktop

Advertising
background image

For answers to your Monogram,

®

GE Profile

or

GE

®

appliance questions, visit our website at

geappliances.com or call GE Answer Center

®

service, 800.626.2000.

170132

Specification Revised 10/11

ZGG420NBPSS - Natural Gas Built-in Outdoor Grill

ZGG420LBPSS - LP Gas Built-in Outdoor Grill

Dimensions and Installation Information (in inches)

Outdoor Built-in Cooktop

These grills are designed to be installed into a non-
combustible enclousure.
To install into combustible enclosures Built-In
Monogram Outdoor grills must use Grill Liner
accessory ZX42JR for 42". Please refer to the
Grill Liner instructions for the details.
• The grill drops into the opening and hangs from

the side flanges. It does not require support from
the bottom.

• The cutout must be completely covered with

non-combustible material such as stone, brick,
ceramic tile, concrete board, etc. The countertop
surface and edges must be flat and level.

• If the countertop has an overhang, it must be

notched or cut back flush with the front face of
the cabinet below.

• Allow at least 12" minimum clearance at the

back of the grill when the exhaust is directed to a
window or surface that is difficult to clean. Allow
at least 4" clearance behind the grill to allow the
hood lid to open. See notched detail below.

• Allow 12" minimum clearance on both sides

and the back of the grill to adjacent vertical
combustible construction.

• These gas grills cannot be used below any type of

overhead construction.

• These grills are designed for outdoor use only. Do

not locate the cooktop in a building, garage or
other enclosed or semi-enclosed area.

• Locate the backside of the grill away from

prevailing winds and avoid cooking in windy
conditions.

41-7/8"

12" Min. to Combustibles

4" Min. Clearance for Lid

to Non-Combustibles

27"

26"

*The weight of the grill is fully supported by

the side trims. The back of the grill overlaps

the back edge of the cutout.

10-1/4" from

Bottom of

Support Flange

*25-1/2"

Countertop Depth

27" to Front

of Control Panel

28-1/2" to Front of Bullnose

40-3/4"

36"

Min.

1-1/8" Min.

10-7/8"

24-1/2"

Grill Cutout

Gas and

Electrical

Locations

Opening

for Optional

Access Doors

** Built-In Monogram Outdoor grills must use

Grill Liner accessory ZX42JR for 42" Built-in
to install into combustible enclosures. Please
refer Grill Liner instructions for the cut-out
dimensions.

Advertising