Storing food, Care and cleaning, What to do before you call for service – Инструкция по эксплуатации Sharp SJ-25P

Страница 7

Advertising
background image

7

Evaporating

pan

Protrusion

Hole

Rail

STORING FOOD

Refrigeration reduces the rate of food spoilage. To
maximize the shelf life of perishable food products,
ensure that the food is of the freshest possible qual-
ity. The following is a general guide to help promote
longer food storage.

Fruit / Vegetables

To minimize moisture loss, fruit and vegetables should
be loosely enclosed in a plastic material e.g. wrap,
bags ( do not seal ) and place in the Vegetable crisper.
Those fruits and vegetables with thick skins e.g. or-
anges do not require wrapping.

Dairy Products & Eggs

• Most dairy products have a use by date on the outer

packaging which informs the recommended tem-
perature and shelf life of the product.

• Eggs should be stored in the Egg holder.

Meats / Fish / Poultry

• Place on a plate or dish and cover with paper or

plastic wrap.

• For larger cuts of meat, fish, or poultry, place to the

rear of the shelves.

• Ensure all cooked food is wrapped securely or placed

in an airtight container.

NOTE:

• Evenly place the food on the shelves to allow the cooling air to

circulate efficiently.

FOR BEST FREEZING

• Quality of foods should be fresh.
• Freeze small quantities of food at a time to freeze them quickly.
• Food should be properly stored or covered and the air should

be removed to seal tightly.

• Evenly place the food in the freezer.
• Label bags or containers to keep an inventory of freezing food.

• Hot foods should be cooled before storing. Stor-

ing hot foods increases the temperature in the
unit and increases the risk of food spoilage.

• Do not block the outlet and inlet of the cool air

circulating circuit with foods or containers; oth-
erwise the foods will not be evenly cooled
throughout the refrigerator.

Do not place food directly in
front of cold air outlet. This
may lead to the food freezing.

IN

OUT

WHAT TO DO BEFORE YOU CALL FOR SERVICE

Before you call for service, check the following point .

IT IS NORMAL

that the outside of a cabinet may be hot when

touched. The hot pipe is in the cabinet in order to prevent dew
generation.

CARE AND CLEANING

Some household cleaning chemicals may affect the
inside surfaces and plastic shelves resulting in split-
ting or cracks occurring.

NOTE:

Switching off your fridge freezer

If you switch your fridge freezer off when you are going away for
an extended period, remove all food, clean the interior thoroughly.
Remove the power cord plug from the power socket and leave
all doors open.

1.Remove the shelves and pockets from the cabinet

and door. Wash them in warm soapy dishwashing
water; rinse in clean water and dry.

2.Clean the inside with a cloth soaked in warm soapy

dishwashing water. Then, use cold water to wipe
off soapy water.

3.Wipe the exterior with a soft cloth each time it is

soiled.

4.Clean the Magnetic door seal with a toothbrush and

warm soapy dishwashing water.

5.Whenever the fridge freezer is moved to clean or

repositioned, the Evaporating pan should be re-
moved and cleaned.

• Do not use polishing powder, benzine, hot water etc.
• If undiluted detergent is used or soapy water is not wiped

off thoroughly, cracking of plastic parts can result.

• Wipe any food oils adhered to plastic components

as they can cause cracking of the plastic surface.

When cleaning all plastic parts
inside this fridge freezer, only use
diluted dishwashing liquid(soapy
water). Make sure that all plastic
parts are thoroughly rinsed with
water after cleaning.

IF YOU STILL REQUIRE SERVICE

Refer to your nearest service agent approved by SHARP.

IT IS NORMAL

for the fridge freezer to produce

the following sounds.
• Loud noise produced by the compressor when op-

eration starts --- Sound becomes quieter after a while.

• Loud noise produced once a day by the compressor

--- Operating sound produced immediately after au-
tomatic defrost operation.

• Sound of flowing fluid (gurgling sound, fizzing sound)

--- Sound of refrigerant flowing in pipes (sound may
become louder from time to time).

• Cracking or crunching sound --- Sound produced by expan-

sion and contraction of inner walls and internal parts during
cooling.

• Squeaking sound --- Sound produced by expansion and con-

traction of internal parts.

Evaporating pan;
How to remove

Move the Evaporating pan to the
left to pull it toward yourself.

How to set

Set the Evaporating pan so that
the two protrusions on the ma-
chine come through its corre-
sponding holes, and move the
pan to the right.

Make sure the back end of the
Evaporating pan rests securely on
the rail. Otherwise water will leak.

Please pay attention to the safety
since the compressor is very hot.

Evaporating

pan

Compressor

Protrusion

Hole

Evaporating pan

Replacing method of the lamp bulb

1.Unplug the refrigerator first to prevent

elevtric shock.

2.Remove the light cover.
3.Replace the lamp bulb with the same

type.

Light cover

base E12, MAX 10W, T-20

Advertising
Эта инструкция подходит к следующим моделям: