AMX UDM-0102 - Manual (Page 15)

UDM-0102 1x2 Multi-Format Distribution Mini-Hub
3 UDM-0102 and UDM-RX02 Operation/Reference Guide
Front Panel Controls
SELECT Pushbutton (Switching Sources)
The UDM-0102 supports 2 AV input sources that can be switched manually.
To switch the inputs at the device, press the SELECT pushbutton on the front of the device.
PRESETS 1/2 Pushbuttons (Executing Presets)
The UDM-0102 supports a total of 2 presets.
1. Select the AV input source (1 or 2), via the SELECT pushbutton.
2. Select either PRESET 1 or PRESET 2 to execute.
Powering The UDM-0102 On/Off
Powering on the Hub: Insert the barrel connector of the power supply into the power
connector on the UDM.
Powering off the Hub: Remove the barrel connector of the power supply from the power
connector on the UDM.
Front Panel LEDs
Power Status LED
Yellow LED on front panel indicates unit is powered.
Active Source LEDs
The front LEDs are grouped by control type and are labeled according to their corresponding port
(connector) numbers on the rear of the unit.
A - Source A is currently selected
B - Source B is currently selected
Status LED
This LED changes from red to green when it receives a valid UDP command, and returns to red after 30
seconds if it has not received anything.
UDM-0102 Specifications (Cont.)
Other AMX Equipment: • Endeleo HD-15 to S-Video Cable (FG-UDM-SVID01)
• Endeleo HD-15 to 3x RCA Breakout Cable (FG-HD15RCA3F)
• RS232 DB9/RJ12 Connection Cable (FG-RS01)
• UDM-RX02 Endeleo Multi-Format Receiver (FG-UDM-RX02)
• UDM-RC10 Endeleo Multi-Format IR Engineering Remote Control
(FG-UDM-RC10)
• UDM-RC02 Multi-Format IR Remote Control (FG-UDM-RC02)
• IR Emitter Module (FG-IR01)
• External IR Receiver Module (FG-IR03)