AMX UDM-0102 - Manual (Page 67)

Protocols and IR Learning
55 UDM-0102 and UDM-RX02 Operation/Reference Guide
Updating the UDM-RX02 With the IR Protocol
1. Ensure the IR protocol has been created previously.
2. In the Status page, click on the port number hyperlink which the device is attached to. It is the
UDM-RX02 which will transmit the IR command to the device’s IR interface.
3. Once the Port properties become visible, select the IR protocol which this UDM-RX02 will
download from the Protocol drop-down menu. This may take a few minutes depending on how
many commands are within the table.
4. A message will appear saying “Loading Protocol – Please wait” once this has disappeared the IR
protocol has been downloaded to the UDM-RX02. IR commands can now be sent from the
UDM-0102 to the device.
Deleting Protocols
1. Click on the Protocols option.
2. To delete a protocol:
Serial protocol: Click the Delete hyperlink in the Serial section.
IR protocol: click the Delete hyperlink in the IR section.
Click Delete all to delete all (Serial and IR) protocols.
A UDM-RX02, which will issue the relevant IR commands to the device, must be
connected to the relevant port via a Cat5/e/6 cable. Remember the IR commands are
stored within the UDM-RX02.
The last created or currently highlighted serial or IR protocol will be deleted when
using the Delete hyperlink.