AirSep MN027-1 - Manual

AirSep Software & Driver Installation for
Focus / FreeStyle 5 Data Interface
1.) Insert the installation CD.
2.) Click setup.exe. and install the software.
NOTE: If the installation does not automatically begin, open My Computer. Within
the My Computer window, click on the CD or DVD drive that contains the
installation files and run setup.exe.
3.) When the installation is complete, you will see the following window:
4.) With the above window open, plug the Focus / FreeStyle 5 Interface
Cable into an open USB port.
5.) The computer will prompt you that it has Found New Hardware.
6.) You will then be prompted that the New Hardware is Installed and
Ready to Use.
7.) Your software and cable drivers are now installed. You may now close
the Installation Window and remove the CD.
8.) The Installation Software created the following icon on your desktop
to access the Interface program.
DO NOT CLOSE THIS WINDOW OR REMOVE THE CD UNTIL THE
CABLE INTERFACE DRIVERS ARE INSTALLED
MN027-1 Rev -
PDF created with pdfFactory Pro trial version www.pdffactory.com