Clinton Electronics CE-PS200 - Manual

v.06.22.11
CLINTON Electronics
6701 Clinton Road
Loves Park, IL 61111
1.800.447.3306 Sales
1.800.549.6393 Support
1.800.633.8712 Fax
www.clintonelectronics.com
Plug in the supplied female pigtail into the male end of the
AC adaptors plug. Place your power supply and pigtail within
reach of your desired outlet to prepare for the next step.
Attach your cable
First determine the length of cable you will need to run from the pigtail
attached to the monitor to the pigtail attached to the AC adaptor (attached
in the previous step). Next, butt splice your cable to the pigtails. After your
wire is inserted, crimp the terminals on the pigtail with a wire crimping tool.
Attach your power supply
Place the power supply within a 3 foot range of your desired outlet.
3 foot maximum
cord range
Crimp Here
Attach the power supply to the mounting surface with 4 screws (not included).
Slide the included power supply mounting bracket over the power supply.
CE-PS200 Installation Guide
MALE PIGTAIL NOT
INCLUDED WITH
CE-PS200
(INCLUDED WITH
MONITOR)
INCLUDED
WITH CE-PS200
1. Confirm Power Requirements
If the monitor you are using is a 24 volt DC monitor, and it draws less
than 60 watts (2.5 amps), the CE-PS200 can power it. (If you are unsure,
please call Clinton Tech Support at 1-800-549-6393).
2. Quick Power
If the monitor is located within 3 feet of the wall outlet, you can simply
plug into the outlet using the included power supply.
3. Determine Splice Requirements
If the monitor is to be mounted further than the cord will reach, you can
splice the cable to add length.
See the chart below to determine cable size and distance.
Only use UL rated cable designed to carry the load.
Wire Gauge Max Wire Length
18GA 75’
16GA 150’
Included Items
• Instruction Sheet
• Power Supply with AC Plug
• Power Supply Mounting Bracket
• Female Pigtail Splice Cable
Required Items
• Phillips Head Screwdriver or Drill with Phillips bit
• Wire Cutters/ Crimpers
• Mounting Screws x 4
Plug in the male pigtail that was included with your monitor into
the plug marked “DC 24V” on the backside of the monitor.
4. Splice the Cable
Installing the CE-PS200