Eddie Motorsports MS107-55 - Manual

Small Block Chevrolet
INSTALLATION INSTRUCTIONS
Engine Prep:

Disconnect battery

Remove existing alternator, a/c compressor, and brackets.

Remove all pulleys and brackets

Clean front of block

Chase the tapped holes in block with a 3/8-16 thread chaser or tap.
Install Mounting Studs:
1. Apply RTV silicone to one end of each mounting stud.
2. Install the 3/8-16 x 4 stud into the bottom passenger side. It should stick out 3 1/2”.
3. Install three remaining studs, sticking out 2 1/2”.