Eddie Motorsports MS149-07 1964-65 - Manual

TRUNK HINGE INSTALLATION INSTRUCTIONS
MS149-07 1964-65 CHEVELLE
1. Before beginning the installation, take note of your trunk lid’s fit and finish. Pay close attention to the width
of the seams, alignment of the trunk lid to the fenders, etc. This will help in the final adjustment of the trunk
lid. NOTE: Do not attempt the installation alone. There are several steps in the installation process that
require two people to complete safely. Be sure to use anti-seize compound on all stainless steel fasteners.
2. Mark the position of the stock hinges on the trunk lid and remove the four bolts holding it to the hinges.
Remove the trunk lid and place it in a safe location.
3. Using a large screw driver or small bar, pry the bent end of the torsion
rod away from the notches on the torsion rod bracket (figure 1-
pictures may differ slightly). This will relieve the pressure on the trunk
hinge. Do the same on both sides.
4. Rotate the bar until the opposite end can be removed from the hinge.
The end of the bar at the hinge has a bend approximately 1 ½” long
that is locked into the hinge. NOTE: Once the spring tension is
released, if you do not plan on saving the bars, you can cut them with a die grinder to ease removal.
5. Locate the head of the hinge pin that holds the hinge into the torsion rod bracket between the outer edge of
the bracket and the inside of the quarter panel. Use a Dremal or die grinder to grind off the head of the pin.
Use extreme caution to prevent damaging the outer body skin.
6. Support the hinge while removing the pin by pulling it towards the center of the car.
7. Install the new billet trunk hinges. You can identify the correct hinge for each side of the car by noting that
the ball stud on the hinge should face outward towards the fender.
8. Use the new stainless steel hinge pins supplied in the kit to mount the
hinges to the bracket. Slide the pins in from the center of the car. Secure
them with the new C-clips.
9. From the center of the car, line up the template provided with the edge
of the torsion rod bracket, under the step of the hinge bracket (figure 2-
pictures may differ slightly).
10. Using the enclosed template, locate and drill two 5/16 holes.
11. Using flat washers on each side of the strut bracket, attach it to the torsion rod bracket using the supplied
stainless steel button head bolts and locknuts (figure 3).
12. Remove the retaining clips from the gas strut sockets and set them
aside.
13. Snap the struts onto the ball studs with the “body” side attached to the
hinge and replace the strut retaining clips.
14. Reinstall the trunk lid, loosely attaching the hinge to the lid with the
supplied stainless steel button head bolts and aluminum washers.
Realign the trunk lid on the car as necessary using your markings as a
guide. Once you are satisfied with the fit, securely tighten the fasteners.
EDDIE MOTORSPORTS IS NOT RESPONSIBLE FOR THE INSTALLATION OF HINGES ON APPLICATIONS OUTSIDE THE
SPECIFIC YEAR AND MODEL OF THEIR INTENDED USE. CONTACT US WITH ANY QUESTIONS 888-813-1293
www.eddiemotorsports.com
Figure 1
Figure 2
Figure 3
Figure 2