Rubbermaid 401165 User Manual

Adaptor kit for automatic flusher, Installation instructions, For crane flush valves

Advertising
background image

Installation Instructions

Adaptor Kit For

Automatic Flusher

Chrome Adaptor

Plastic Bracket

Blue Washer

2 Pink Washers

White Plastic

Push Rod

Components:

4. Install and tighten chrome adaptor
with plastic bracket into Crane valve
with crescent wrench.

Due to the variences in the tolerance of Crane Flush Valves,
2 plastic rod extenders have been included to match
their wide range of specifications.

5. Install the black plastic
push rod extension onto
end of AutoFlush metal
push rod. Press push rod
extension tip against hard
surface until extension is
fully seated on push rod.

1. Remove Crane handle assembly.

2. Install small blue washer into Crane valve

handle opening.

3. Slide plastic bracket opening over

small threaded end with back plate
facing the wall and flat end behind
the flush valve.

6. Install AutoFlush unit onto
chrome adaptor with 2 pink
washers. Tighten Chrome nut.

401165

For Crane Flush Valves

Black Plastic

Push Rod

If the plastic rod does not contact the flush piston

(which would start the flush cycle) remove the

black plastic rod extender and repeat step 5 with

the white plastic rod extender. The removal of 1

pink washer may also be used to adjust for the

variation in the Crane tolerances.

Plastic

Push Rod

Pink

Washer

Chrome

Adaptor

Plastic

Bracket

Blue

Washer

Advertising