Turbo Action 23254E Turbo Hydro 350 Pro Electronic Shift Valve Body (PRND21) - Manual

Part #23254E 1 4/16/03,9/22/04,8/4/05,4/29/08,4/22/09,1/19/11
CHEETAH ELECTRONIC-SHIFT VALVE BODY (PRN321)
Part #23254E (No Engine Braking in 1st)
“This valve body requires a deep transmission pan!”
Fits: Turbo Hydro “350” & “375B” 1969-86 (Non-Lockup)
FIRST, READ INSTRUCTIONS CAREFULLY, THEN PROCEED TO INSTALL VALVE BODY BY FOLLOWING
EACH STEP INDIVIDUALLY.
Includes: 1 - Valve Body
1 - 23093 Special Valve Body Spacer Plate
1 - 23096P 2-3 Performance Plate
1 - 23097 Spacer to Valve Body Gasket (Small)
1 - 23098 Spacer to Case Valve Body Gasket (Large)
1 - 23138 Set Screw
1 - 23099C Pan Gasket
2 - 23103 Filter Gaskets
1 - U00691 1/4” Tap
2 - U17381 Super Solenoids (Installed)
2 U17381R Retainers (Installed)
1 - U17388E Connector
2 - U17389 Snap Plugs
2 - U23174 Washers 5/16”
2 - U23175 Bolts 3” x 5/16”
2 - U23176 Manifold Spacers
1 - U23170 Manifold
1 - U23130 Modulator Plug
STEP #1: Transmission should be cool before installing. Also, place gear shift selector in neutral. If
vehicle is on the ground, secure so it will not roll.
STEP #2: Remove drain plug in pan and drain oil. Olds., Buick and Pontiac do not have drain plug, and
therefore, must be drained by dropping transmission pan. Recommend leaving a couple of
bolts attached until most of the oil has drained.
STEP #3: Remove transmission oil filter by removing two screws.
STEP #4: Remove kickdown valve wire by pulling pin out of kickdown lever in valve body.
NOTE: These pieces can be discarded as they are no longer used (Fig. #1).
STEP #5: Before removing valve body, note position of the gear shift linkage hooked to the valve body
(Fig. #2). Remove 18 bolts from valve body.
CAREFULLY lower valve body and at the same
time slide angled shift pin lever from gear shift selector. DO NOT drop valve body or manual
valve with angled shift pin.
1535 Owens Road, Jacksonville, FL 32218
Phone (904) 741-4850 *** FAX (904) 741-4853
www.turboaction.com