Aube Technologies TH146-P-DE User Manual

Th146-p-de, Introduction 1.1, Installation 2.1

Advertising
background image

TH146-P-DE

400-280-004-C 11/29/06 1/9

TH146-P-DE

Installation Guide

Programmable Heat Pump Controller

-

The TH146-P-DE programmable controller can be used to control a
heat pump system. The following devices can be connected to the
controller:



heat pump



auxiliary heating (furnace)



air recirculation fan



humidifier



dual-register meter (dual energy)



remote control device (for the unoccupied mode)

• CT280-HP-2H1C control module
• TH146-P console with two wall anchors and mounting screws
• AC144-03 outdoor temperature sensor (3 m or 10 ft) with

mounting clip (see section 2.7)

• RC845 relay (see section 2.5)
• AC146-410 plenum temperature sensor (see section 2.8)
• CT241 telephone controller (see section 2.10)

Install the control module on the furnace’s electrical panel, away
from the heat source.

Install the console in the area where you wish to measure the tem-
perature and humidity. Avoid locations where there are air drafts
(e.g., top of staircase or air outlet) or stagnant air (behind a door).
Do not install the console on a wall hiding air ducts nor expose it to
direct sunlight.
NOTE: If this controller replaces an existing thermostat, the wires
that were connected to the thermostat can be used to connect the
console. The maximum wire length is 30 m (100 feet).

1)

Choose a location about 5 ft. (1.5 m) above the floor on an
inside wall.

2)

Loosen the captive screw under the console.

3)

Detach the console from its base by pulling the bottom section.

4)

Secure the base using the wall anchors and screws.

5)

Connect the console to controller terminals TH and TH (no
polarity).

Connect the heat pump to the controller as follows:

• Controller terminals R and C to heat pump terminals R and C

(see section 2.4)

• Controller terminal Y to heat pump terminal Y
• Controller terminal O/B to heat pump terminal O
• Controller terminal WW to heat pump terminal WW

TH146-P User Console

CT280-HP-2H1C Control Module

AC144-03 Outdoor
Temperature Sensor

1. Introduction

1.1

Applications

1.2

Supplied Parts

1.3

Accessories

2. Installation

2.1

Control Module (CT280-HP-2H1C)

2.2

User Console (TH146-P)

2.3

Heat Pump

Advertising