Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 52)

Specifications
50
900-0095-01-00 Rev A
Electrical Specifications, 120 Vac/60 Hz Models
Product Name FP1-1 FP1-2 FP1-3 FP1-4
Inverter Model VFX3524 VFX3648 GVFX3524 GVFX3648
Grid-Interactive No No Yes Yes
Anti-Islanding Protection N/A N/A UL1741-2005/ IEEE1547 UL1741-2005/ IEEE1547
Sell Current N/A N/A < 5% < 5% Total
Harmonic
Distortion
Invert Voltage N/A N/A 2% Typical 2% Typical
Output Waveform True Sine Wave
Nominal 24 Vdc 48 Vdc 24 Vdc 48 Vdc
Battery
Voltage
Operating Range 20-30 Vdc 40-60 Vdc 20-30 Vdc 40-60 Vdc
Recommended Minimum Battery Capacity 200 Amp-hours 100 Amp-hours 200 Amp-hours 100 Amp-hours
For Models with FM80 Charge Controller:
Maximum PV Array Wattage 2000 Wdc
STC
4000 Wdc
STC
2000 Wdc
STC
4000 Wdc
STC
PV Input Voltage Range 50-150 V
OC
25-150 V
OC
50-150 V
OC
25-150 V
OC
PV Operating Voltage Range 50-145 Vdc 25-145 Vdc 50-145 Vdc 25-145 Vdc
PV Maximum Open Circuit Voltage 150 V
OC
including local temperature correction factor
PV Maximum Short Circuit Current 64 A I
SC
Protection
AC and DC Surge Protection MOV Current Diversion with LED Warnings
PV Ground Fault Protection 80 Adc Breaker (Detection >0.5 A)
For Models with FLEXnet DC Battery Monitor:
State of Charge Display 5-LED Bar Graph, or 1% - 100% scale, using MATE2
Battery Capacity Range 100 to 10,000 Amp-hours
Current Resolution 0.1 Amps DC
Shunt A 500 amp, 50 mV
Shunt B 100 amp, 10 mV
Certifications ETL Listed to UL 1741, CSA 22.2 #107.1
Warranty 5-year limited warranty standard/Optional 10-year warranty
Mechanical Specifications, 120 Vac/60 Hz Models
Product Name FP1-1 FP1-2 FP1-3 FP1-4
Part Numbers VFX3524 VFX3648 GVFX3524 GVFX3648
Dimensions (H x W x D) 33.50” (85.09 cm) x 19.75” (46.26 cm) x 12.87” (32.68 cm)
Weight 98 lb (44.5 kg)
Enclosure and Mounting Plate Materials Aluminum
Mounting Wall Mount (Bracket Included)
AC Inputs 60 Aac Bypass Assembly
AC Outputs 20 Aac Outlet and Breaker
AC and PV terminals Accepts #12 AWG to1/0 AWG
Charge Controller Terminals Accepts #12 AWG to 1/0 AWG
Integrated Communications MATE2 for system operation information; FLEXnet DC Battery Monitor for battery information