Pop & Lock PL1700C User Manual

Pop & Lock For the car

Advertising
background image

Installation Instructions

Tailgate Lock PL1700, PL1700C

Chevrolet Colorado

2004 - Up

GMC Canyon

PATENT PENDING

3

Remove the two 6 mm bolts from inside of the

tailgate to free the handle assembly.

6

Using the supplied key, test the lock by

locking and unlocking the tailgate.

4

Lift the tailgate into the up position but do not

fully engage in the latches. While supporting the

tailgate with one hand, pull the bottom of the

handle out first (a), then carefully pull out the

handle assembly from the top (b).

Contents:

Lock Assembly, 2 keys, Instructions, Warranty Card.

Technical Support:

Call 1-800-342-5911

[email protected]

Tools Required:

Philips screwdriver, Ratchet,

10 mm Socket, Ratchet extension.

2

Carefully detach the two latch rods from the

plastic clips and move aside.

1

Open the tailgate and if applicable, remove the

tailgate bed-liner. Using a philips screwdriver,

remove the screws holding the access panel.

Remove the access panel and set aside.

b

a

5

Install the Pop & Lock assembly into the

tailgate following Steps 2, 3 & 4 in reverse order

while making sure that it is in the lock position as

seen in picture below. Make sure that the

bottom small tabs snap onto the tailgate before

tightening the 6 mm bolts.

Small tabs

7

Re-install the access panel and bed-liner if
applicable.

For the latest instructions please visit www.popandlock.net

12-27-11

Advertising
This manual is related to the following products: