Amana AKES3060 - Manual (Page 11)

11
Installing Modules
WARNING !
To avoid risk of personal injury, all controls must be in
"OFF" position before removing or installing modules.
Installing Coil and Smoothtop Modules
1.
Turn all controls to OFF.
2. Hold module with terminals pointing toward rear of
cooktop.
3. Place end of module into cooktop well with terminals
facing rear of well.
• If module pan from grille or griddle module is in
well, remove before installing coil module.
Front
Rear
Well
4. Slide module towards rear of cooktop until module
engages. Lower front of module into well.
Removing Coil and Smoothtop Modules
1.
Turn all controls to OFF. Make sure module is cool.
2. Using tab on front of module, lift up slightly.
• Do not lift module too high. Lifting module too high
can cause damage to terminals.
3. Pull module toward the front of cooktop and carefully
lift it out.
Installing Smoke Control Grill™ Module
1.
Turn all controls to OFF.
2. Place module pan with terminal opening towards plug.
Front
Rear
Well
Module pan
Terminal
opening
3. Place grease shield into module pan.
• Smoke control grille element will not operate if
shield is not in place.
4. Hold grille element with terminals pointing toward rear
of cooktop.
• Slide terminals into plug as far as they go.
• Check grille element to make sure it is fully
engaged into plug.
5. Place Grille on module pan.