Racing Electronics Gemini 5 - Manual

e e emini
Race
Intercom
System
Operating Instructions
Single Scanner Input Operations
When operating the system using two headsets and a single scanner (input)
the toggle switch (see photo below) must be in the UP position(All) on BOTH
HEADSETS.
Two Scanner Input Operations
When operating the system using two headsets with a scanner plugged into
each headset you must have the toggle switch on BOTH HEADSETS set to
the DOWN position. (see photo below)
Intercom System Power
Inside the right ear cup of each headset is a 9-Volt battery that powers the
system. We always recommend that you always have a spare battery for
each headset on hand. We also recommend using alkaline batteries.
Cables - 3-Pin Umbilical Cable
You should route the cables where they are the most convenient for your
seating arrangement(these cables can plug into either side of the headset).
Arrangements for multiple headsets and inputs are provided inside
this guide.
Volume Controls Input Toggle Switch
Headset Volume
DOWN
Isolate
UP - ALL
quieter
louder
Mic Volume
* More instructions on back of pamphlet