Checkers Bandit Goggle Retainer GR9652 - Manual

GOGGLE
RETAINERS
INSTALLATION INSTRUCTIONS
KNOT FOR ADJUSTING GOGGLE TENSION
GOGGLE ATTACHING STRAP
ELASTIC CORD
RETAINING RING CHANNEL
BUTTON
BAND
GOGGLES IN STORAGE
POSITION
MADE IN USA
INSTRUCTIONS
1. Place retaining ring over top of cap and position channel over back
edge. Pull band down front of cap (see illustration).
2. Remove and discard the elastic headband or strap from your
existing goggles.
3. Attach goggles to goggle retainer by sliding attaching strap through
headband slots of goggles (both sides) and button strap closed (see
illustration).
4. Verify fit and retention before using.
NOTE: More tension may be applied to the goggles by shortening
the distance between the knots of elastic cord. Cut off excess
cord when proper tension is reached. (Caution: make sure
goggles will reach the storage position after adjusting tension).
To eliminate a gap at the temple, remove the elastic cord from
the goggle retaining ring and rethread the elastic cord through
the desired alternate slot on each end of the retaining ring
tube. Reconnect the goggle attaching strap (refer to step 3).
CAP MODEL NO. GR9652
INSTRUCTIONS
1. Place retaining ring over top of hat and position channel over back
edge of brim. Pull band down front of hat (see illustration).
2. Remove and discard the elastic headband or strap from your
existing goggles.
3. Attach goggles to goggle retainer by sliding attaching strap through
headband slots of goggles (both sides) and button strap closed (see
illustration).
4. Verify fit and retention before using.
NOTE: More tension may be applied to the goggles by
shortening the distance between the knots of elastic
cord. Cut off excess cord when proper tension is
reached. (Caution: make sure goggles will reach the
storage position after adjusting tension). To eliminate
a gap at the temple, remove the elastic cord from the
goggle retaining ring and rethread the elastic cord
through the desired alternate slot on each end of the
retaining ring tube. Reconnect the goggle attaching
strap (refer to step 3).
HAT MODEL NO. GR9662
KNOT FOR ADJUSTING GOGGLE TENSION
GOGGLE ATTACHING STRAP
ELASTIC CORD
RETAINING RING CHANNEL
BUTTON
BAND
GOGGLES IN STORAGE
POSITION
• Goggles will come off and eye protection will be eliminated if helmet
becomes dislodged or is knocked off the wearer's head. Wear helmet chin
straps or retain goggles separately from helmet if this potential exists.
• Do not use where contact with direct or open flame exists.
• Manufacturer and/or distributor cannot guarantee performance because
we are unable to control and assure proper use.
FAILURE TO COMPLY WITH THE ABOVE CAUTION CAN CAUSE
LOSS OF EYE PROTECTION AND RESULT IN EYE INJURY.
WARNING! WARNING! WARNING!
www.checkersindustrial.com
620 COMPTON ST • BROOMFIELD, CO 80020
PH: 720-890-1187 • FAX: 720-890-1191 • TOLL FREE: 800-438-9336
#ZIS-GR
Ver: 2/11