Haws 2000SMS User Manual

Model 2000sms brita, Hydration station, With lifecycle control

Advertising
background image

3/14

Model 2000SMS

Page 1 of 5

No. 2077011 (3)

1455 Kleppe Lane

Sparks, NV 89431-6467 (888) 909-4297

website:

www.Britahydrationstation.com
















QUICK START REFERENCE


























© 2014 Haws

®

Corporation – All Rights Reserved

HAWS

®

and other trademarks used

in these materials are the exclusive property of Haws Corporation.

The BRITA trademark and logo are registered trademarks of Brita, LP and used under license by Haws Corporation. All rights
reserved.

Model 2000SMS

Brita

®

Hydration Station

TM

with Lifecycle Control


INSTALLATION GUIDE

NOTE: A Class A ground-fault circuit interrupter
(GFCI) shall be installed in the branch-circuit
supplying power to this unit.

CAUTION! Prior to making any electrical
connections, verify with a voltmeter that power
from the service panel is off.

SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL, OR REQUIRE REPLACEMENT PARTS, PLEASE CALL:

TECHNICAL SUPPORT:

1-800-766-5612

HOURS OF OPERATION: MON-THURS 7:00a.m. - 4:00p.m PT, FRI 7:00a.m.- 1:00p.m. PT

PARTS LIST: 1 Brita

®

Hydration Station

TM

, 1 filter cartridge, 1 plastic drain basin, 1 hex key, 1

grommet.

RECOMMENDED TOOLS: Phillips screwdrivers, level.

REQUIRED PARTS (NOT SUPPLIED): 1/2” screwdriver stop, 3/8” tubing (to be used for water
supply inlet), 6 1/8” x 3” zinc-plated steel toggle bolts, 6 zinc-plated steel 1/8” fender washers.

PRODUCT INSTALLATION: When installing this product, local, state or federal codes should be
adhered to. This unit is certified for indoor use only.

SUPPLY LINE: Minimum recommended line size is 1/2" IPS with 30-90 PSI (2-6 ATM) flowing
pressure; supply water is to be cold water supply. Intended for municipal water only.

PLUMBING CONNECTIONS: Inlet is 3/8” O.D. push-in type fitting. If a waste is desired, the Haws
6470 retrofit 1-1/4” O.D. waste kit may be used.

ELECTRICAL CONNECTIONS: 115VAC, 60HZ, approx. 0.14A. Unit is equipped with a standard
115VAC plug.

RATED SERVICE FLOW: 0.5 GPM (2725L/day)
OPERATING TEMPERATURE: 35–100

°

F (1.7–37.8

°

C)

OPERATING PRESSURE: 30-90 PSI
FILTER CAPACITY: 2500 gallons (9464L) or 1 year
REPLACEMENT FILTER CARTRIDGE: Brita® Electronic Lifecycle Control Filter Model 6429

Advertising