Agilent Technologies N8201A User Manual
User’s guide
Advertising
Table of contents
Document Outline
- Introducing the N8201A Performance Downconverter
- Contents
- Software Installation
- Installing Software and Instrument Drivers
- Step 1. Install Microsoft .NET Version 1.1
- Step 2. Install the Agilent I/O Libraries
- Step 3. Install the IVI Shared Components
- Step 4. Install the Agilent Synthetic Instrument Finder
- Step 5. Install the Agilent Synthetic Instrument GUI
- Step 6. Install the IVI-COM Drivers
- Step 7. Install the Agilent N8201A Performance Downconverter User Interface
- Installing Optional Software and Instrument Drivers
- Installing Software and Instrument Drivers
- Hardware Setup and Configuration
- Step 1. Unpack the N8201A Performance Downconverter
- Step 2. Connect LAN Cables and Turn On Power
- Step 3. Verify Connection with Synthetic Instrument Finder
- (Optional) Step 4. Connect to the Agilent N8201A Option H02 Spectrum Analyzer GUI
- (Optional) Step 5. Connect to an SA Remote Web Server
- (Optional) Step 6. Verify Operation < 3 GHz
- (Optional) Step 7. Verify Operation > 3 GHz
- Troubleshooting
- Alternative Ways to Verify Connectivity to the PC
- How to Use the Synthetic Instrument Finder
- How to Reset the LAN Configuration
- How to Set a Static IP Address
- How to Troubleshoot Connectivity Problems on the Network
- How to Determine a PCs Configuration Settings
- If the Instrument was Unable to Join the LAN
- If the LAN LED is Red
- If the Instrument’s IP Address or Hostname Cannot be Found with Ping
- If the Instrument is Not Found by the Synthetic Instrument Finder
- If the Instrument’s Hostname and PC Cannot Communicate
- If the Instrument Web Page is Not Visible
- If the Software Driver Will Not Open the Connection
- Using the Agilent Synthetic Instrument GUI
- Front and Rear Panel Features
- Preventive Maintenance
- Service, Support, and Safety Information
- Glossary