Hawkeye Torque Anchor - Manual

This document contains the recommended procedures to install and refurbish the Dynamic Torque Anchor.
A.) Installation - Initial Function Test
B.) Installation
C.) Disengage
D.) Service & Refurbishment
Installation and Refurbishment Instructions
Dynamic Torque Anchor
Torque Anchor Installation / Refurb Instructions, April 2014
Figure 1 Figure 2 Figure 3
Figure 4
1
1.) Run the Torque Anchor, box end up, into the first joint of casing (Fig.
1)
2.) Set the Torque Anchor with 300 ft-lb of right-hand torque (Fig. 2)
3.) Examine the contact points to ensure proper engagement of the an-
chor blocks in the ID of the casing.
4.) Once satisfied, relax the right-hand torque (Fig. 3) and the anchor is
ready to be run to the desired depth.
1.) Run the torque anchor to the desired depth. The anchor must be in-
stalled box end up and below the pump (Fig. 1).
2.) At the desired depth, apply approximately 300 ft-lb of right-hand
torque (Fig. 2) on the anchor to engage the anchor blocks to the cas-
ing wall.
3.) The setting torque can be locked in and pump operation started.
Note: To avoid disengaging the anchor when starting or stopping the
pump, pre-torque the tubing string.
1.) Stop pump.
2.) Relax setting torque (Fig. 3).
1.) Disassemble the torque an-
chor to its individual compo-
nents (Fig. 4):
► Body (A)
► Anchor Blocks (B)
► Retaining Ring (C)
► Spring (D) *
► Hex Socket Screw (E) *
* Do not reuse these components.
2.) Clean the body, anchor
blocks and retaining rings
using varsol, sand blasting or
other means to provide a
clean part for inspection
3.) Inspect the parts for cracks,
deformations from over-
torque and corrosion. Dam-
aged parts should not be
reused. Use discretion when
examining the anchor blocks.
If there is any doubt with con-
tinued use, replace the an-
chor blocks.
4.) Reassemble the Torque An-
chor using the Assembly Pro-
cedure.
► 1/4” Allen Key
► Torque Wrench
► Solvent / Cleaning Solution
► Sand Blaster
► Heavy Duty rubber band
► Band clamp / Cinch Rope
Contents Refurb / Reassembly Tools
Parts Required
A.) Installation - Initial Function Test
B.) Installation
C.) Disengage
D.) Service and Refurbishment
E.) Reassembly
QTY Part
► 1 Torque Anchor Refurb. Kit for your size of anchor.
C
A
E
C
D
B
300 FT-LB