EnzoTech NV-295GTX-LE - Manual

1
Use a cross tip screw driver to take off all screws shown in
fig1& fig2 marked in red circles.
CAUTION: Remove the bar code may break the original
warranty of your graphic card.
2
3 4
5
Use a flat tip screw driver to open all
connections shown in fig3 & fig4
(marked in red circles). Note: to open
a connection, please follow the method
shown in fig5.
Use a cross tip screw driver to take off the screws shown in
fig6 marked in small red circles. Disconnect the fan cable
marked in large red circle (there are total 9 small and 1 large
red circles).
Clean up all residual glue on the graphic card.
Evenly apply (F) shown on left figure on chipsets
marked in red squares.
As shown in fig10, install (A) on the
back plate with (D) in all 14 places
marked in red.
As shown in fig11 & fig12, put (E) on
top of the back plate then screw (C)
from the other side to install the back
plate on the graphic card.
(A) NV-295GTX-LE Water Block
(B) ThermalTape-90x150 (mm)
(C) M3x6mm Screw x 3
(D) M2x6mm Screw With Spring x 14
(E) Nylon threaded spacer x 3
(F) Artic Silver Ceramique Thermal Grease (OEM) x 1
(G) Bolt x 2
A
F
G
D D
E
A
A
C
B B
B B B
B
B
B
Cut (B) shown on left figure and attach the
thermal tape on positions shown in fig8 and
fig9.
Thermal tape
WARRANTY
H
H
H
H
H
H
H
H H
H H
H H H
(E)Nylon threaded spacer