Kenwood KSC-SW01 - Manual (Page 6)

ENGLISH
6
English
Main unit Remote control
Install the remote control unit on the vehicle by the
provided Velcro tape.
0 1 A
Installation
Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary.
Caution:
• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on
the opposite side such as a gasoline tank, brake pipe; or wiring harness, and be careful not to cause scratches or other damage.
• Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the ve-
hicle compartment.
• Fix the product firmly so that it will not be moved by vibrations or impacts during driving.
7 Fixing the subwoofer
2 Machine screw x 4
1 Fixture x 2
Caution:
1 2
Attach the fixtures 1 to the speaker unit securely
using the machine screws 2. Be careful so that the
connected cords do not get in between the speaker
unit and fixtures
1.
3 Tapping screw x 4
Drill the pilot holes for ø 3.6 mm screws on the sheet
metal section of the vehicle , and attach the speaker
unit to the vehicle using the tapping screws
3.
7 Installing the remote control unit
6 Remote control
Rear panel
5 Velcro tape
(Softer surface)
Vehicle
Caution:
Install the remote control unit in a position that does not
come in the way of driving operations. Avoid installing
it in a place subject to direct sunlight or direct hot wind
from the heater. Otherwise, the product may be degraded
and a fire hazard may result. Remove dirt from the installa-
tion position before attaching the Velcro tape.
PHASE switch
(Phase select switch)
FREQUENCY control knob
(Cut-off frequency control knob)
VOLUME control knob
(Input sensitivity control knob)
Fuse exchange
7 Removal 7 Insertion
Fuse Cover
Fuse holder
Replacement
fuse 10 A
1 Open the cover.
2 Grasp the fuse and pull up.
1 Insert the fuse gently into the fuse holder and
push in all the way with your finger.
2 Close the cover.
Caution: Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 10A.
Exchange with the speci-
fied capacity fuse.
Drill four pilot holes for
ø 3.6 mm screws.
5 Velcro tape
(Harder surface)
Name of each part
This portion becomes slightly
hot ter than other por tions
because it functions as the
radiator of the heat generated
by the amplifier.
B61-1344_EN.indd 6 B61-1344_EN.indd 6 09.5.28 11:53:19 AM 09.5.28 11:53:19 AM