Kenwood DPX504U - Manual (Page 62)

62
| DPX504U/ DPX404U/ DPX304
Bluetooth Setup
Bluetooth Setting
You can select the following Bluetooth Setting
items.
1
Press the [LOG] button for at least 1 second.
2
Turn the [VOL] knob and press it when the
desired item is displayed.
Select “Settings”.
3
Select the Setting item
Turn the [VOL] knob and press it when the
desired item is displayed.
Display Overview
“Settings”
“PAIRING”
“Device
Registration”
Register a Bluetooth device (pairing).
Refer to <Registering Bluetooth device>
(page 64) .
“Phone
Selection”
Select a cell-phone or Bluetooth audio player
connection.
Refer to <Selecting the Bluetooth device You
Wish to Connect> (page 65) .
“Audio Selection”
“Special Device
Select”
Register a Bluetooth device (pairing).
Refer to <Registering Bluetooth device>
(page 64) .
“Device Delete” Cancel registration of the Bluetooth device.
Refer to <Deleting a Registered Bluetooth
device> (page 66) .
“SMS Download” Download a short message.
Refer to <Downloading the SMS> (page 70) .
“Voice Tag” Registers voice for voice recognition and voice
to select the Phone number category in Phone
book.
- <Adding a Voice Dialing Command> (page 67)
- <Setting a Voice Command for Category>
(page 68)
“Detailed Setup” Move to detailed item.
“PIN Code Edit” Specify the PIN code required when registering
this unit using the Bluetooth device.
Refer to <Registering PIN Code> (page 65) .
“Auto Answer” Answer a call automatically after lapse of the
preset time interval for automatic answer.
“OFF”/ “0SEC” – “8SEC” – “99SEC”
“Bluetooth HF/
Audio”
You can specify output speakers for hands-free
voice communication and Bluetooth audio
sound.
“Front”: Outputs voice from the front speakers.
“All”: Outputs voice from the front and rear
speakers.
“Call Beep” You can output a beep from the speaker when
a call comes in.
“ON”: Beep is heard.
“OFF”: Beep is canceled.
“BT F/W Update” Display the version of the firmware of this unit.
“Mic Gain”*
Adjust the sensitivity of the microphone for a
telephone call. Adjust the voice of caller. Setting
to “+” increases the voice volume.
“–3” – “0” – “+3”
“NR Level”* Reduce the noises generated by surrounding
environment without changing the microphone
volume. Adjust the voice of caller when it is
not clear. Setting to “+” increases the noise
reduction.
“–3” – “0” – “+3”
“Echo Cancel
Level“*
Adjust the level of echo cancellation. Setting to
“+” increases the echo cancel reduction.
“–2” – “0” – “+2”
( : Factory setting)
* Function of KCA-BT300
4
Make a setting
Turn the [VOL] knob to select a setting value,
and then press the [VOL] knob.
5
Exit BT Settings mode
Press the [LOG] button for at least 1 second.
Remarks
• “Auto Answer” (Setting the Time Interval for Automatic
Answer)
This function automatically answers (responds to) a call
after lapse of the preset time interval for automatic answer.
“OFF” : Does not answer the phone call automatically.
“0” : Automatically answers the phone call at once.
“1s” – “99s” : Automatically answers the phone call after
lapse of 1 – 99 seconds.
Function of DPX504U with KCA-BT200/BT300 (Optional Accessory)
VOL LOG 4 ¢