Midco G69B - Manual

WARNING: If the information in these
instructions is not followed exactly, a fire or
explosion may result, causing property
damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch;
do no use any phone in the building.
Immediately call your gas supplier from
another buildingÕs phone. Follow the gas
supplierÕs instructions.
If you cannot reach your gas suppler, call
the fire department.
Installation and service must be performed
by a qualifed installer, service agency or
the gas supplier.
BURNER
MODEL
BILL OF MATÕL
NUMBER
DATE CODE
WIRING
DIAGRAM
FOR SERVICE CONTACT:
name
address
phone
In the United States, Installation must conform with local
codes or , in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1-latest edition available from
American National Standard
Institute. Further reference
should be made to the recommendation of your fuel
supplier.
In Canada, Installation must conform with local codes or, in
the absence of local codes, with Installation Codes for Gas
Burning Appliances and Equipment, CGA Standard
CAN/CGA 1-B-149.1 or 2. When the conversion burner
burner is used on a Forced Air Central Furnace, the two
yellow and black warning labels in the literature envelope
shall be attached in accordance with Installation Code,
CGA Standard CAN/CGA 1-B149, Clause 5.4.4.4. Further
reference should be made to the recommendation of your
fuel supplier.
WARNING: Additions, changes, conversions, and
service must be performed by an authorized MIDCO
representative, service agency, or the fuel supplier. Use
only MIDCO specified and approved parts.
INSTALLER: Inform and demonstrate to
the user the correct operation and
maintenance of the gas utilization
equipment. Inform the
user of the
hazards of storing flammable liquids
and vapors in the vicinity of this gas
utilization equipment and remove
such hazards. Affix this manual
and associated literature to the
conversion burner.
CODE COMPLIANCE IS THE SOLE
RESPONSIBILITY OF THE INSTALLER.
INSTALLATION AND
SERVICE INSTRUCTIONS
UNIPOWER
G56B G57B
G58B G69B
Power Burners
USER: Retain this manual for future reference. If other than routine service or
maintenance as described in this manual and associated literature is required,
contact a qualified service
agency. DO NOT ATTEMPT REPAIRS. An inadvertent
service error could result in a dangerous condition.
PRINTED IN U.S.A.
598
8470-86
SAFETY INFORMATION TERMS: The following terms are used to identify hazards, safety precautions or special notations and
have standard meanings throughout this manual. When you see the safety alert symbol and one of the safety information terms,
as shown below, be aware of the hazard potential.
DANGER: Identifies the most serious hazards which will result in severe personal injury or death.
WARNING: Signifies a hazard that could result in personal injury or death.
CAUTION: Identifies unsafe practices which would result in minor personal injury or product and property damage.
¥
¥
¥
¥
MIDCO International Inc.
4140 WEST VICTORIA STREET ¥ CHICAGO, ILLINOIS 60646 ¥ (773) 604-8700 FAX: (773) 604-4070 ¥ http://www.midco-intl.com