Midco Unipower G-Series - Manual

Installation and Service Instructions
Midco International Inc.
4140 West Victoria Street Chicago, Illinois 60646
tel 773.604.8700 fax 773.604.4070 web www.midco-intl.com 4 0 0
8 4 4 9 - 0 6
Printed in U.S.A.
In the United States, installation must conform with local codes or
in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1-latest edition available from American
National Standard Institute. Further reference should be made to
the recommendation of your fuel supplier.
In Canada, installation must conform with local codes or in the
absence of local codes, with Installation Codes for Gas
Burning Appliances and Equipment, CGA Standard
CAN/CGA 1-B-149.1 or 2. When the conversion burner is used
on a Forced Air Central Furnace, the two yellow and black
warning labels in the literature envelope shall be attached in
accordance with Installation Code, CGA Standard CAN/CGA
1-B149, Clause 5.4.4.4. Further reference should be made to
the recommendation of your fuel supplier.
WARNING: Additions, changes, conversions and service
must be performed by an authorized Midco
representative, service agency or the fuel supplier. Use
only MIDCO specified and approved parts.
I N S TALLER: Inform and demonstrate to the user the
correct operation and maintenance of the gas
utilization equipment. Inform the user of the hazards
of storing flammable liquids and
vapors in the
vicinity of this gas utilization equipment and remove
such hazards. Affix this manual and associated
literature to the conversion burner.
CODE COMPLIANCE IS THE SOLE RESPONSIBILITY OF THE
I N S T A L L E R .
USER: Retain this manual for future reference. If o t h e r
than routine service or maintenance as described in this
manual and associated literature is required, contact a
qualified service agency. DO NOT ATTEMPT REPAIRS.
An inadvertent service error could result in a
dangerous condition.
Unipower G-Series
Power Burn e r s
BURNER
MODEL
BILL OF MAT'L
NUMBER
DATE CODE
WIRING DIAGRAM
FOR SERVICE CONTACT:
name
address
phone
SAFETY INFORMATION TERMS: The following terms are used to identify hazards, safety precautions or special notations
and have standard meanings throughout this manual. When you see the safety alert symbol and one of the safety
information terms as shown below, be aware of the hazard potential.
DANGER: Identifies the most serious hazards which will result in severe personal injury or death.
WARNING: Signifies a hazard that could result in personal injury or death.
CAUTION: Identifies unsafe practices which would result in minor personal injury or product and property damage.
Warning: If the information in these instructions
is not followed exactly, a fire or explosion may result,
causing property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in the building.
• Immediately call your gas supplier from
another building's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.