LBL Lighting MO Curve - Manual

1
G P I : ENERAL RODUCT NFORMATION
This product is suitable for dry locations only.
Installation Instructions for
Flexible Vertical Conductive Connectors
950MOFXV
MONORAIL
Adjust the Angle
Loosen the inner set screws on one connector with an
Allen wrench.
Pull the wires out of the connector.
The joining wires on the flexible connectors are pre-
cut for a 90-degree bend. For any angle other than
90 degrees, follow these instructions to adjust the
wires. Otherwise, skip ahead to section 2.
JOINING WIRES
SET SCREWS
SET SCREWS
STRIPPED
WIRES
Trim the wires to the proper length and strip off the last
3/8” of the insulation.
Insert the stripped wires into the connector.
Tighten the set screws with an Allen wrench to secure the
wires.
1.0 1.0
1.1
1A
1A
1A
1B
1
4
2
3
5
1
4
5