Campbell Scientific CM110, CM115, CM120 Tripod Installation - Manual (Page 27)

Tripod Installation Manual Models CM110, CM115, CM120
• Route the 14 AWG wire from the ground lug on the bottom side of the
enclosure to the ground lug on the base of the tripod (FIGURE 6-14).
Strip 1/2 in. of insulation from each end of the wire. Insert wire ends into
the ground lugs and tighten.
FIGURE 6-14. Enclosure with the –MM bracket
6.1.7.2 Enclosure Mounting to Tripod Leg
An enclosure ordered with the –LM bracket has a bracket on each side of the
enclosure, and a U-bolt bracket for securing the enclosure to a tripod leg.
Attach an enclosure with the –LM mounting bracket to the tripod base as
follows:
• Slide the keyhole notches in the upper and lower corners of the –LM
bracket over the two extended Phillips head screws located on the tripod
base as shown in FIGURE 6-15B.
• Remove the washers, nuts, and U-bolt from the U-bolt bracket. Install the
bracket as shown in FIGURE 6-15C. Tighten the nuts on the U-bolt until
the lock washers are compressed.
• Route the 14 AWG wire from the ground lug on the bottom side of the
enclosure to the ground lug on the base of the tripod (FIGURE 6-15).
Strip 1/2 in. of insulation from each end of the wire. Insert wire ends into
the ground lugs and tighten.
U-bolt
–MM Bracket
19