Campbell Scientific GPS16-HVS Garmin GPS Receiver User Manual
Page 29
Appendix D. Garmin16-HVS Setups
2. If the target sentence mode is 0 (disable) or 1 (enable), the target sentence
description field must be an identifier for one of the sentences that can be
output by the GPS sensor.
3. If either the target sentence mode field or the target sentence description
field is not valid, the PGRMO sentence will have no effect.
4. $PGRMO,GPALM,1 will cause the GPS sensor to transmit all stored
almanac information. All other NMEA 0183 sentence transmission will be
temporarily suspended.
5. $PGRMO,,G will cause the COM 1 port to change to GARMIN data
Transfer format for the duration of the power cycle. The GARMIN mode
is required for GPS 16/17 series product software updates.
TABLE D-3. Supported NMEA 0183 Sentences
Order and Size
Sentence Default Output
Maximum Characters
GPRMC
Yes
74
GPGGA
Yes
82
GPGSA
Yes
66
GPGSV
Yes
70
PGRME
Yes
35
GPGLL
No
44
GPVTG
No
42
PGRMV
No
32
PGRMF
No
82
PGRMB
Yes
40
PBRMM Yes
32
PGRMT
Once per minute 50
In TABLE D-3 default Output indicates NMEA sentences that are Garmin16-
HVS defaults. CSI turns off all output except the GPGGA sentence. The time
required to output a NMEA sentence can be determined by multiplying the
maximum number of characters by 10 then dividing the result by the baud rate.
Selected sentences will be transmitted at a periodic rate based on the selected
baud rate and the selected output sentences. The sentences will be output
contiguously. Regardless of the baud rate, the sentences are reference to the
PPS signal immediately preceding the GPRMC sentence, or whichever
sentence is output first.
D-3