Campbell Scientific Wireless Sensor Network (CWB100, CWS220, and CWS900) User Manual
Wireless sensor network
Advertising
Table of contents
Document Outline
- Revision and Copyright Information
- Warranty
- Assistance
- Table of Contents
- Wireless Sensor Network
- 1. Understanding a Wireless Sensor Network
- 2. Specifications
- 3. Getting Started: Creating a Wireless Sensor Network
- 3.1 Hardware and Software Required for a WSN
- 3.2 Creating a Model of the WSN
- 3.3 Configuring the Devices in the WSN
- 3.4 Sending the Sensor Configuration File to the Datalogger
- 3.5 Programming the Datalogger
- 3.6 Connecting the CWB100 to the Datalogger
- 3.7 Powering CWS Sensors and Initiating Auto-discovery
- 3.8 Verify that Data is being Transmitted
- 3.9 Physical Connections
- 4. Programming the Datalogger
- 5. CWS Button and LED Behavior
- 6. Testing the Network
- 7. Maintenance
- 8. Troubleshooting
- Appendix A. Using DevConfig for CWS Setup
- Appendix B. Measurement Names and Meanings
- Appendix C. Battery Life
- Campbell Scientific Contact Information