Samsung ML-2540-XAA - Manual (Page 27)

Media and tray_ 27
1. With one hand press and hold the guide lock, and with the other hand,
hold the paper length guide and support guide together. Slide the paper
length guide and support guide to locate them in the correct paper size
slot.
2. Flex or fan the edge of the paper stack to separate the pages before
loading papers. Insert the paper into the tray.
3. After inserting paper into the tray, adjust the support guide so that it
lightly touches the paper stack.
4. Squeeze the paper width guides and slide them to the desired paper
size marked at the bottom of the tray.
• Do not push the paper width guide too far causing the media to
warp.
• If you do not adjust the paper width guide, it may cause paper
jams.
• Do not use a paper with more than 6 mm curl.
Loading paper in the tray
Tray 1
1. Pull out the paper tray . And adjust the tray size to the media size you
are loading. (See "Changing the tray size" on page 26.)
2. Flex or fan the edge of the paper stack to separate the pages before
loading papers.
3. And place paper with the side you want to print facing down.
4. Set the paper type and size for the tray 1. (See "Setting the default tray
and paper" on page 25.)
If you experience problems with paper feeding, check whether the
paper meets the media specification. (See "Print media
specifications" on page 57.)
Manual tray
The manual tray can hold special sizes and types of print material, such as
postcards, note cards, and envelopes. It is useful for single page printing on
letterhead or colored paper.
Tips on using the manual tray
• If you select Manual Feeder for Source from your software
application, you need to press
(cancel button) each time you print
a page and load only one type, size and weight of print media at a
time in the manual tray.
• To prevent paper jams, do not add paper while printing. This also
applies to other types of print media.
• Print media should be loaded face up with the top edge going into
the manual tray first and be placed in the center of the tray.
• Always load the specified print media only to avoid paper jams and
print quality problems. (See "Print media specifications" on page 57.)
• Flatten any curl on postcards, envelopes, and labels before loading
them into the manual tray.