Samsung KS17LBKWK-TRU - Manual (Page 42)

deleting Plug and Play monitor, find 'Plug
and Play monitor' by searching new
Hardware.
MagicTune is an additional software for the
monitor. Some graphic cards may not
support your monitor. When you have a
problem with the graphic card, visit our
website to check the compatible graphic
card list provided.
http://www.samsung.com/monitor/magictune
MagicTune™ doesn't
work properly. Have you changed your
PC or video graphic
card? Download the latest program. The program
can be downloaded
http://www.samsung.com/monitor/magictune .
Visit the MagicTune™ website and download the installation software for MagicTune™
MAC.
Check the following items if there is trouble with the monitor.
1. Check if the power cord and the video cables are properly connected to the computer.
2. Check if the computer beeps more than 3 times when booting.
(If it does, request an after-service for the main board of the computer.)
3. If you installed a new video card or if you assembled the PC, check if the installed adapter (video)
driver and the monitor driver.
4. Check if the scanning ratio of the video screen is set at 50Hz ~ 160 Hz.
(Do not exceed 60 Hz when using the maximum resolution.)
5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode,
remove the Display Adapter at the "Control Panel→System→Device Administrator" and then
reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur, contact an authorized service center .
Q & A
Question Answer
How can I change the frequency? Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the
version of the driver used. (Refer to the computer or the
video card manual for details.)
How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution at the Control
Panel→Display→Settings.
* Contact the video card manufacturer for details.
How can I set the Power Saving
function? Windows ME/XP/2000 : Set the function at BIOS-SETUP of
the computer or the screen saver. (Refer to
Windows/Computer Manual).
The monitor makes a sound when it is
turned on. This is normal as some sound may be generated when the
metal case and the electromagnet, which are installed to
block any electromagnetic waves, interact with each other.
How can I clean the outer case/Picture
tube? Disconnect the power cord and then clean the monitor with
a soft cloth, using either a cleaning solution or plain water.
Do not leave any remains of the detergent nor scratch the
case. Do not allow any water to go inside the monitor.