2 before requesting service, Before requesting service -2 – Samsung LS24B5HVFH-ZA User Manual

Page 51

Advertising
background image

Troubleshooting

5-2

5-2

Before Requesting Service

Please check the following before requesting After-Sales service. If the problem continues, please contact your nearest
Samsung Electronics Service Center.

A blank screen appears / I cannot turn the product on

Is the power cord connected properly?

Check the connection status of the power cord.

Is the <Check Signal Cable> message displayed on the
screen?

(Connected using the D-sub cable)

Check the cable connecting the PC and the product.

(Connected using the DVI cable)

If the message appears on the screen even if the cable is
properly connected, recheck the input signal by pressing the [

] button of the product.

Is the <Not Optimum Mode> message displayed on the
screen?

This occurs when the signal from the graphics card exceeds
the maximum resolution or the maximum frequency of the
product.

In this case, set up the appropriate resolution and the fre-
quency for the product.

Is a blank screen displayed and does the power LED blink at
a 1 second interval?

1. This occurs when the power saving function is running.

If you click the mouse or press any key, the screen will be
turned on.

2. This occurs when two monitors are connected,

<MagicReturn> is <On> and Magictune is running. In this
case, characters on the Magictune OSD may appear
corrupted. To run the Magictune, the <MagicReturn> must
be set to <Off>. Please restart your PC, set the
<MagicReturn> to <Off> and run the Magictune.

Did you connect with a DVI cable?

If you connect the DVI cable when the PC has booted up or if
you reconnect the DVI cable after disconnecting the cable
while using a PC, the screen may not be displayed because
some graphics cards do not output the video signal.

In this case, reboot the PC while the DVI cable is connected.

THE IMAGE IS TOO LIGHT OR TOO DARK.

Adjust the <Brightness> and <Contrast>.

(Refer to the <Brightness>, <Contrast>)

The display brightness can differ according to the mode set for <MagicAngle>.

If <MagicBright> is set to <Dynamic Contrast>, the display brightness can differ according to the input signal.

The on screen adjustment menu (OSD) does not appear.

Did you cancel the screen adjustment?

Check if the OSD Adjustment Lock function is set to Off.

The color is weird / The picture is displayed in black and white

Is the entire screen displayed in the same color as if viewing
the screen through a cellophane paper?

Check the cable connection to the computer.

Reinsert the graphics card into the computer completely.

Check if the <Color Effect> is set to <Off>.

Is the graphics card configured correctly?

Set up the graphics card referring to the user manual.

Advertising
This manual is related to the following products: