Samsung SCX-6555N-XBG - Manual (Page 55)

55
10. Enter the Share name of the server.
11. Check the box next to Anonymous if you want to permit
unauthorized persons to access the SMB server.
This box is unchecked by default.
12. Enter the login name and password.
13. Enter the domain name of the SMB server.
14. Enter the Scan File Folder under shared folder for storing the
scanned image.
15. Click Apply.
SCANNING ORIGINALS AND SENDING VIA SMB/
FTP (SCAN TO SERVER)
You can scan an image and send it to a total of 5 destinations via the SMB
or FTP.
Preparation for scanning to SMB/FTP
Select the folder and share it with the machine in order to receive the
scanned file.
1. Turn your networked computer on and open the web browser.
2. Enter your machine's IP address as the URL in a browser.
3. Click Go to access the SyncThru Web Service.
4. Click Machine Settings > SMB Setup > Server List. The Server List is
then displayed on the right side of the screen.
5. Click Add.
6. Select the index number from 1 to 20.
7. Enter a name in Alias for the Setup for the corresponding Server List
entry. This name will be displayed on your machine.
8. Select IP Address or Host Name.
9. Enter the server address in dotted decimal notation or a host name.
10. Enter the server port number, from 1 to 65535.
The default port number is 139.
11. Enter the share name of the server.
12. Put a check mark next to in Anonymous if you want to allow the SMB
server to be accessed by unauthorized persons.
By default, this is unchecked.
13. Enter the login name and password.
14. Enter the domain name of the SMB server.
15. Enter the location for storing the scanned image. This is the location you
entered in step 7..
16. Click Apply.
Scanning and sending to SMB/FTP server
1. Press Scan from the Main screen.
2. Press Scan to Server.
3. Place the originals face up in the DADF. Or you can place a single
original document face down on the scanner glass.
4. Adjust the document settings in the Image tab.
5. Select Duplex and Resolution in the Basic tab.
The next steps are for SMB server setting using SyncThru Web
Service, and the setting for FTP server is the same as SMB. Apply the
same steps for setting up the FTP server.
If the authentication message shows, enter User Name and Password.
This message shows only when the network administrator has set the
authentication in SyncThru Web Service. (See "Managing your
machine from the website" on page 21.)