Samsung KS17CNKWH-XAZ - Manual (Page 54)

Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call
the phone number on the
Information section or contact your dealer .
Symptom Check List Solutions
No images on the
screen. I cannot turn
on the monitor. Is the power cord
connected properly? Check the power cord connection
and supply.
Can you see " "
on the screen?
Check the signal cable connection.
If the power is on,
reboot the computer to
see the initial screen
(the login screen),
which can be seen. If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows ME/XP/2000) and then
change the frequency of the video
card.
(Refer to the
Preset Timing Modes )
Note: If the initial screen (the login
screen) does not appear,
contact a
service center or your dealer .
Can you see " " on
the screen?
You can see this message when the
signal from the video card exceeds
the maximum resolution and
frequency that the monitor can
properly handle.
Adjust the maximum resolution and
frequency that the monitor can
handle properly.
There is no image on
the screen.
Is the power indicator
on the monitor blinking
at 1 second intervals? The monitor is in PowerSaver mode.
Press any key on the keyboard to
activate the monitor and restore the
image on the screen.
The image on the
screen is shaking. Check the monitor
configuration to see if
it is in Interlace Mode.
(Interlace Mode:
Vertical frequency
43Hz, 87Hz(i), etc) The signal from the video card
exceeds the maximum resolution
and frequency of the monitor.
Are there any Move the monitor away from