Samsung DVD-VR320-AXAA - Manual (Page 28)

28 - English
S
ystem Setup
Digital Output
1. PCM : Converts to PCM(2CH) 48kHz
audio. Select PCM when using the
Analog Audio Outputs.
2. Bitstream : Converts to Dolby Digital Bitstream
(5.1CH). Select Bitstream when
using the Digital Audio Outputs.
DTS
1. Off : Doesn’t output digital signal.
2. On : Outputs DTS Bitstream via digital output
only. Select DTS when connecting to a DTS
Decoder.
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. Off : You can enjoy the movie with the standard
Dynamic Range.
2. On : When the Movie soundtracks are played at
low volume or from smaller speakers, the
system can apply appropriate compression to
make low-level content more intelligible and
prevent dramatic passages from getting too
loud.
Setting Up the Audio
Options
Be sure to select the correct Digital Output or
no audio will be heard.
When DTS soundtrack is played, sound is not
output from Analog Audio Output.
Allows you to setup the audio device and sound staus
settings depending on the audio system in use.
1 With the unit in Stop mode/No Disc mode, press
the MENU button.
2 Press the …† buttons to select Setup, then press
the ENTER or √ button.
3 Press the …† buttons to select Audio, then press
the ENTER or √ button.
Audio setup menu will be displayed.
4 Press the …† buttons to select the desired audio
option, then press the ENTER or √ button.
5 Press the …† buttons to select the desired item,
then press the ENTER or √ button.
No Disc Audio
Digital Output : PCM √ √
DTS : Off √ √
Dynamic Compression : On √ √
MOVE SELECT RETURN EXIT
Setup
Timer Rec.
No Disc Setup
System √ √
Clock Set √ √
Channel Set √ √
Language √ √
Audio √ √
Video √ √
Parental Control √ √
MOVE SELECT RETURN EXIT
Setup
Timer Rec.
Note
■ Press the RETURN or œ button to return to the
previous menu.
Press the MENU button to exit the menu.
Note
Note
00588A(00)-VR320-1/XAA-eng 3/3/05 7:26 PM Page 28