Samsung HT-C7530W-XAA User Manual

Page 23

Advertising
background image

English

23

02

Connections

NOTE

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is
too close to the product, some sound interruption may be heard due to interference.

If you use a device such as a microwave oven, wireless LAN Card or any other device that uses
the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due
to interference.

The transmission distance from the product to the wireless receiver module is about 33 feet (10m),
but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is
between the product and the wireless receiver module, the system may not operate at all, because
the radio wave cannot penetrate metal.

If the product doesn't make wireless connection, the system needs ID Setting between the
product and wireless receiver module. With the product turned off, press the remote control's
number buttons "0"

J"1"J"3"J"5" and turn on the product. With the wireless receiver module

turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds.

CAUTION

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.

For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.

If no sound is heard from the wireless surround speakers, switch the mode to DVD 5.1
channel or Dolby Pro Logic

II.

In 2-CH mode, no sound will be heard from the wireless surround speakers.

Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit

If you attach the included Toroidal ferrite core to the power cord of the man unit, it will help to
prevent RF interference from radio signals.

Pull the fi xing tab of the Toroidal ferrite core to open it.

Make a loop twice in the main unit power cord.

Attach the Toroidal ferrite core to the main unit power cord as shown below, and then press it until it clicks.

!

1.

2.

3.

iPod

HT-C7530W_XAA_0817.indd 23

HT-C7530W_XAA_0817.indd 23

2010-08-17 8:49:40

2010-08-17 8:49:40

Advertising