Samsung DV361GWBEWR-A3 - Manual (Page 8)

8
TROUBLE SHOOTING
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before
servicing, unless testing requires power.
COMPONENT TESTING PROCEDURES
Component Electrical Testing (with ohmmeter)

Thermistor resistance 10K Ω @ 25°C 77°F
 Thermostat 1 resistance < 1Ω
 Thermostat 3 resistance < 1Ω
- If resistance is infinity, replace thermostat 3.
 Thermostat 2 resistance < 1Ω
- If resistance is infinity, replace thermostat 2.
 Heater resistance 10 Ω
- If resistance is infinity, replace Heater.
 Measure resistance of the following terminal
1) Door switch : open
Terminal : “COM” - “NC” (1-3) < 1Ω
Terminal : “COM” - “NO” (1-2) : ∞ Ω
2) Door switch push: On
Terminal : “COM” - “NC” (1-3) : ∞ Ω
Terminal : “COM” - “NO” (1-2) < 1Ω
 Belt Cut-off S/W
- Lever open: Resistance value < 1Ω
- Lever push: Resistance value : ∞ Ω
 Lamp resistance 80~100 Ω (Violet & gray)
 Motor (Electronic & GAS)
Contacts
 = Contact closed
Centrifugal Switch (Motor)
2.88Ω between
Pin# 3 and 4
3.5Ω between
Pin# 4 and 5
Function 1M 2M 3M 5M 6M
Start
Run
Technical_information-02365J-01_EN.indd 8 2012-09-11 �� 3:09:10