Installing accessories, Precautions to take when installing accessories, Installing a memory dimm – Samsung SCX-6555N-XBG User Manual

Page 120: Installing a memory module

Advertising
background image

Installing accessories_ 120

installing accessories

Your machine is a full-featured model that has been optimized to meet most of your printing needs. Recognizing that each user may
have different requirements, however, Samsung makes several accessories available to enhance your machine’s capabilities.

This chapter includes

Precautions to take when installing accessories

Installing a memory DIMM

Replacing the Stapler

Enabling Fax feature after installing the fax option kit

PRECAUTIONS TO TAKE WHEN INSTALLING

ACCESSORIES

Disconnect the power cord

Never remove the control board cover while the power is turned on.

To avoid the possibility of an electrical shock, always disconnect the

power cord when installing or removing ANY internal or external

accessories.

Discharge static electricity

The control board and internal accessories (network interface card or

memory module) are sensitive to static electricity. Before installing or

removing any internal accessories, discharge static electricity from your

body by touching something metal, such as the metal back plate on any

device plugged into a grounded power source. If you walk around before

finishing the installation, repeat this procedure to discharge any static

electricity again.

INSTALLING A MEMORY DIMM

Your machine has a dual in-line memory module (DIMM) slot. Use this

DIMM slot to install additional memory.

Your machine has 256 MB of memory which can be expanded to 512 MB.

The order information is provided for optional memory DIMM. (See "Memory

module" on page 118.)

Installing a memory module

1. Turn the machine off and unplug all cables from the machine.
2. Open the control board cover by grasping it and slide toward you.

3. Take out a new memory DIMM from the plastic bag.

4. Holding the memory module by the edges, align the memory module on

the slot at about a 30-degree tilt. Make sure that the notches of the

module and the grooves on the slot fit each other.

5. Press the memory module into the slot with care until you hear a “click”.

1

control board

cover

The notches and grooves illustrated above may not match those

on an actual DIMM and its slot.

Do not press the memory module strongly or the module may be

damaged. If the module does not seem to fit into the slot properly,

carefully try the previous procedure again.

Advertising
This manual is related to the following products: