Samsung DVD-R100-XAX - Manual (Page 9)

English - 15
Step 1: Unpacking
Method 1 : Antenna + DVD
Recorder + TV : No Cable box
You can record non-scrambled channels by selecting the
channel on the DVD Recorder. Also use this Method if
you watch channels without cable box.
Method 2 : Antenna +Cable box +
DVD Recorder + TV : Cable box
with many scrambled channels
You can record channels by selecting the channel on the
cable box. You cannot record one channel while watch-
ing another channel. Be sure that the cable box is turned
on.
Accessory
Check for the supplied accessories below.
● Video/Audio Cable (AC39-42001R)
● RF Cable for TV (AC39-42001J)
● Remote Control (AK59-00023A)
● Batteries for Remote Control (AAA Size)
(4301-001035)
● Instruction Manual (AK68-00427A)
● Quick Guide (AK68-00493A)
There are several ways to connect your DVD Recorder.
Select one of the following antenna connections that
best suits you below.
● Method 1 : Antenna + DVD Recorder + TV : No Cable
box
● Method 2 : Antenna +Cable box + DVD Recorder +
TV : Cable box with many scrambled channels
● Method 3 : Antenna + DVD Recorder + Cable box
+TV : Cable box with a few scrambled channels
Step 2: Connecting the Antenna
Cable
■ If you are using an off-air antenna that has
300-ohm twin flat leads, use an external
antenna connector (300-75 ohm adaptor :
not supplied) to connect the antenna to
the DVD Recorder.
■ If you have two separate antennas (one
VHF and the other UHF), use a UHF/VHF
combiner-adaptor (available at most elec-
tronics shops) to connect the antenna to
the DVD Recorder.
■ The VHF/UHF RF OUT jack of this prod-
uct sends only signals received through
the antenna. It does not output Audio/
video signals. You must connect
audio/video cables to view Video from the
unit. (i.e. DVD playback)
NOTE
14 - English
A Quick Overview presented in this guide will give you
enough imformation to start using the recorder.
C onnecting &
S etting Up
Quick Overview
Quick Overview .....................................................14
Step 1 : Unpacking.................................................15
Step 2 : Connecting the Antenna cable .............. 15
Step 3 : Connecting the Video cable.....................16
Step 4 : Connecting the Audio cable ....................18
Step 5 : Connecting the external devices .............20
Step 6 : Connecting the Power cord.....................21
Step 7 : Preparing the Remote Control.................21
Step 8 : Initial Setup...............................................23
This section involves various methods of connect-
ing the DVD player to other external components
and required initial setting modes. Step 1 : Unpacking
Step 2 : Connecting the Antenna Cable
Step 3 : Connecting the Video Cable
Step 4 : Connecting the Audio Cable
Step 5 : Connecting the external devices
Step 6 : Connecting the Power Cord
Step 7 : Preparing the Remote Control
Step 8 : Initial Setup
†
†
†
†
†
†
†
● Note to CATV system installer: This reminder is pro-
vided to call CATV system installer’s attention to
Article 820-40 of the National Electrical Code
(Section 54 of Canadian Electrical Code, Part I), that
provides guidelines for proper grounding and, in par-
ticular, specifies that the cable ground shall be con-
nected to the grounding system of the building as
close to the point of cable entry as practical.
C
onnecting & Setting UP
C
onnecting & Setting UP