Samsung SECR410ZRAMTR - Manual (Page 137)

Settings 134
Phone Settings
Remember to always turn your phone on and check for adequate signal strength
before placing a call.
Note: When you dial an emergency number, you phone locks itself to the emergency location that
answered the call and locks itself in 911-Only mode, blocking from dialing any number but an
emergency number.
Store Emergency Numbers
1. From the Settings menu, press (for Phone Settings), and
for Security.
The “Enter Code” prompt appears in the display.
2. Enter the four-digit lock code using the keypad.
Note: The default lock code is the last four digits of your mobile phone number.
The “Enter Code” prompt disappears and the Security menu appears in
the display.
3. Press
for Emergency #
.
4. Press , , or to select one of the three emergency
numbers.
5. Enter the emergency number (up to 32 digits in length).
6. Press to save the number that you entered.
7. P ress Cancel (right) soft key ( ) to discard your entry and return to the
previous menu.
Call Emergency Numbers in Lock Mode
1. In standby mode, enter the emergency number via the keypad.
2. Press to place the call.
Reset Phone
Reset Phone returns all setup parameters (except for the Contacts entries) to their
factory default values.
Caution!: Before selecting Reset Phone, contact your Wireless Carrier. Invoking Reset Phone may erase
settings made by your Wireless Carrier from your phone, resulting in loss of service.
1. From the Settings menu, press (for Phone Settings), and
for Security.
The “Enter Code” prompt appears in the display.
OK