Samsung FPT5084X-XAA - Manual (Page 43)

English - 43
PC Display
Using Your TV as a Computer (PC) Display
Setting Up Your PC Software (Based on Windows XP)
The Windows display-settings for a typical computer are shown below. The actual screens on your PC will probably be
different, depending upon your particular version of Windows and your particular video card. However, even if your actual
screens look different, the same basic set-up information will apply in almost all cases. (If not, contact your computer or
Video Card manufacturer.)
1 First, click on Control Panel on the Windows start menu.
2 When the control panel window appears, click on Appearance and Themes and a
display dialog-box will appear.
3 When the control panel window appears, click on Display and a display dialog-box will
appear.
4 Navigate to the Settings tab on the display dialog-box.
The correct size setting (resolution)
Optimum: 1920 x 1080 pixels
If a vertical-frequency option exists on your display settings dialog box, the correct value
is 60 or 60 Hz. Otherwise, just click OK and exit the dialog box.
Display Modes
If the signal from the system equals the standard signal mode, the screen is adjusted automatically. If the signal
from the system doesn’t equal the standard signal mode, adjust the mode by referring to your videocard user
guide; otherwise there may be no video. For the display modes listed below, the screen image has been optimized
during manufacture.
• The interlace mode is not supported.
• The TV operates abnormally if a non-standard video format is selected.
• The table above conforms to IBM/VESA regulations and is based on using the PC Input.
➢ • When this TV is used as a PC display, 32-bit color is supported.
• Depending on the manufacturer, your PC display screen might appear different. (and depending on your particular version of Windows.)
Check your PC instruction book for information about connecting your PC to a TV.
• If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 48.4KHz (horizontal).
• In some cases, abnormal signals (such as stripes) might appear on the TV screen when the PC power is turned off (or if the PC is disconnected).
If so, press the SOURCE button on the remote control or TV panel to enter a VIDEO mode. Also, make sure that the PC is connected.
D-Sub Input
Display Mode RESOLUTION Horizontal Frequency(kHz) Vertical Frequency(Hz) Pixel Clock Frequency(MHz) Sync Polarity(H/V)
IBM
720 X 400 31.469 70.087 28.322 -/+
640 X 480 31.469 59.940 25.175 -/-
VESA
640 X 480 37.861 72.809 31.500 -/-
640 X 480 37.500 75.000 31.500 -/-
800 X 600 35.156 56.250 36.000 +/+
800 X 600 37.879 60.317 40.000 +/+
800 X 600 48.077 72.188 50.000 +/+
800 X 600 46.875 75.000 49.500 +/+
1024 X 768 48.363 60.004 65.000 -/-
1024 X 768 56.476 70.069 75.000 -/-
1024 X 768 60.023 75.029 78.750 +/+
1280 X 1024 63.981 60.020 108.000 +/+
1280 X 1024 79.986 75.025 123.000 +/+
1600 X 1200 75.000 60.000 162.000 +/+
1920 X 1080 66.587 59.934 138.500 +/-
HDMI/DVI Input
Display Mode RESOLUTION Horizontal Frequency(kHz) Vertical Frequency(Hz) Pixel Clock Frequency(MHz) Sync Polarity(H/V)
IBM
720 X 400 31.469 70.087 28.322 -/+
640 X 480 31.469 59.940 25.175 -/-
VESA
800 X 600 37.879 60.317 40.000 +/+
1024 X 768 48.364 60.000 65.000 -/-
1280 X 1024 63.981 60.020 108.000 +/+
1920 X 1080 66.587 59.934 138.500 +/-
BN68-01094P-00Eng.indb 43 2007-04-13 ¿АИД 5:32:06